The Beginner’s Guide to Machines

Waterjet Cutting Cost

You will note that waterjet cutting has gained immense popularity over the years. You will easily realize that a good number of people appreciate the aspect of understanding the cost of waterjet cutting. It is necessary to understand that there are various costs incurred in running waterjet cutting processes. It is necessary to indicate that there are a number of variables as well as power requirements that will need to be taken into consideration. It is certain that water and abrasive will attract given costs too. You need to understand that there are primarily six different configurations. They come with different expenses. It is therefore necessary to understand all the costs attached to this waterjet cutting. They will every so often include the following.

There is a cost that is featured in water. You will actually find that this is what will cost you the least among all. This water is relied on for cutting as well as cooling. You will find that 3.5 dollars will every so often be used on a 1000 gallon. You will learn that it will often cost you between 1200 and 2500 dollars in a year. It is imperative to mention that there will be a need for you to pay an extra amount for the sewer as well. This will every so often vary with the location. There are particular regions that will attract a bigger amount than the others. It is necessary to understand that the intensifier pump will also have to be operated. This will often depend on power. You will realize that you will be required to pay in the range of 3700 to 9400 dollars each year for power. This will depend on your usage. These figures are given for pumps of between 50 and 125HP.

There is also a cost attached to abrasive. It will often turn out to be the most costly of all. You will realize that there are usually two main types of garnets available. You will find that there is usually the alluvial as well as the hard rock garnet. You will realize that hard rock is appreciated as being sharper. It is for this reason that it will tend to cut faster. You will note that the alluvial garnet will be characterized by rounded grains. This means that you will need to pay more for the hard rock. You will also need to focus on the expenses that come with the abrasive flow rate. It will every so often call for you to spend about 26000 to 55000 dollars each year.

You will also have to check the cost of wear and tear. It is not uncommon to replace certain parts such as the orifice. There are also miscellaneous pump part costs. They will cost you up to 32000 dollars each year.

Getting Creative With Resources Advice

Questions About Equipment You Must Know the Answers To